CYBER KITTY HALF MASK

This cast urethane half mask is semi flexible and hand painted with color shifting and metallic paints. This mask is meant for costuming and is not rated for any sort of safety or PPE use.

The elastic straps can be adjusted using the bra slides, the swiveling D rings are permanently attached. Please be aware that the paint near the D rings could wear off with use despite the rubber washers sandwiched near the mask surface.

Buyer may need to adjust the mask through gentle heat shaping ( see below) and by adjusting or replacing the attached straps. This mask will have some foam added for comfort but it may need more padding added using upholstery foam glued with hot glue depending on individual fit. Please wear the top elastic strap so that it goes over the widest part of the back of your head. DO NOT OVERTIGHTEN THE TOP STRAP. A too tight top strap will make the mask fit an an uncomfortable angle over the nose and will suck to wear.

The basics:

- This is for one (1) painted, sealed and ready to wear urethane mask. It will come with adjustable elastic straps and inside foam padding. Padding may need to be cut down or added to for the mask to fit correctly.

- These are produced one at a time in my own studio.

- Please be sure to provide the correct address when placing your order, all orders will be shipped to the address im provided with and cannot be changed after the order is placed. No exceptions, sorry!

Be sure to check out my mask info section to learn more about these masks: https://missmonster.myshopify.com/pages/mask-care-info

 - Please do not buy a mask if any of the above is an issue!

- If you want any more info on buying from my shop please go through the FAQ/policy page in my shop: http://missmonster.myshopify.com/pages/f-a-q

Mask info and heat shaping:

-This mask fits most faces but a perfect fit is not guaranteed.

 - This urethane is sensitive to heat. Please keep it out of direct very hot sunlight as it can warp under it's own weight when too hot.  You can use a heat gun or hair dryer to heat the back of the mask until it becomes pliable. Set the shape you want by gently pressing to your face while warm and leaving on an upturned bowl or object to hold the shape while it cools.

- Do not use this as safety equipment or a welding mask or anything else but costuming. I am not responsible for injuries sustained through improper use of this mask.

By purchasing this you acknowledge that you have read and agree with the shop's policy page and have read and agree to comply with all of the information on this page.

By buying this piece you are directly supporting an independent artist. Thank you!