ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
ROBOT KITTY EAR BLANKS
missmonster

ROBOT KITTY EAR BLANKS

Regular price $40.00 $0.00 Unit price per

These kitty ears were sculpted in clay and then cast in translucent urethane. They are 3 1/4" long and slightly curved on the inside to attach to a hat or helmet.  This is for a PAIR.

PLEASE NOTE: The edges are a bit thin on the inside edge of the inner ear, please be careful not to crack when sanding. You can use a drop of thick super glue on the back to add extra strength if you want!

The back of the ears will need to be sanded gently, there will be some mold flashing and seams!

I use a HIGH HEAT hot glue to attach my ears, regular hot glue can work too but the high heat stuff is super tough. Be sure to sand and roughen the inside of the ear to get glue to stick better! I have also drilled a hole through the circular screw-like parts on the ends and used a chicago screw to attach without needing glue. The length of the screw will depend on what you are attaching it to, keep in mind the thickness of the ear section and the material you are attaching it to. I used a Russian desert army hat for the pictured build:

The ear can be painted so that the light only shows out of the tip or whatever section you choose. Use a bit of clay to make a "mask" shape and then prime with black spray primer- i also brushed on some Stuart Semple ultra black flat paint to further obscure any light coming through since i was going to light mine with an LED. Then just remove the clay mask and paint normally! Any paint that accidentally goes over the unpainted clear bit can be scraped off with the flat blade of an exacto knife. Gloss the unpainted tip to really make the bright plastic pop!