WASTELAND HARPY DIY BLANK MASK- ROUND 2

PLEASE ALLOW 2-3 WEEKS. This is a small batch run.

This mask will come with the translucent amber hollow decorative "filters" that also glow in the dark. They can be lit up by drilling a hole into the sides of the mask and inserting a miniature glowstick or a tiny light.

-Please order to your current, correct address. If you may be moving soon, please have it sent to a friend. I cannot send a mask to an address that is different from the one included in your order. If you need an address changed i will have to cancel the order and ask you to re-order- this might cause you to lose your place or miss out if these sell out quickly!

-This is a limited run. Only a certain number of blank masks will be made.

-The photos of the finished mask is just to show what can be done. You will receive a white , unpainted mask.

- Painted, ready to wear masks will be available as they are completed. No pre-orders for painted versions this time!

The basics:

- This is for one (1) cast white urethane unpainted, unfinished mask with two (2) amber clear faux filters. The finished pictures are just an example of what can be done.

- These are produced one at a time in my own studio. The buyer will need to sand/remove the flash edges, fill any small surface air bubbles and heat to widen the mask to fit their own face if needed. The space in between the beak is thin to open the space between the upper/lower beak for easier breathing.

- A plastic nipper, a rasp , sandpaper or a dremel can be used to refine edges. Here is a little more detailed info. Buyer can add soft cloth lining to the inside for comfort. Some craft/paint/kit building knowledge is recommended. I cannot provide build help beyond the info included here and in links provided.

- Please be sure to provide the correct address when placing your order, all orders will be shipped to the address im provided with and cannot be changed after the order is placed. No exceptions, sorry!

- There are no refunds on pre-orders.

- Please do not buy a mask if any of the above is an issue!
- If you want any more info on buying from my shop please go through the FAQ/policy page in my shop: http://missmonster.myshopify.com/pages/f-a-q

Mask info:

- You will receive a BLANK white urethane mask. The finished photos are just an example of what the mask can look like when completed.

- THIS IS NOT A FUNCTIONING RESPIRATOR and is not designed to be converted into one. This is not a piece of safety equipment, this is a wearable prop. Please use common sense.

- This mask can be primed with any spray primer ( auto or otherwise) and painted with acrylics or whatever you prefer. Seal with clear coat to prevent scuffs after painting.

- This urethane is sensitive to heat. Please keep it out of direct sunlight as it can warp under it's own weight when hot. If the mask does not fit, It can be heat shaped by immersing it in very hot water and shaping gently while soft. You can also use a heat gun or heat in the oven at around 175 degrees for a few minutes- or immerse it in hot water. Set the shape you want by immersing the warm mask in cold water or leaving on an upturned bowl or object to hold the shape while it cools.

- This is a project that should be attempted by adults or under adult supervision. Please read all safety warnings on materials you use. I am not responsible for any injuries sustained while customizing these masks.

-This mask fits most faces but a perfect fit is not guaranteed. Cannot be worn with glasses.

- Do not use this as safety equipment or a welding mask or anything else but costuming. Please don't make dumb choices with this. I am not responsible for injuries sustained through improper use of this mask.

By purchasing this you acknowledge that you have read and agree with the shop's policy page and have read and agree to comply with all of the information on this page.