YAY NEW MASK!
http://missmonster.myshopify.com/products/robo-fox-diy-blank-mask
PLEASE read everything here carefully!
As with all of my mask pre-orders there will be a 3-8 week production time. This means the time it takes for me to produce a batch of masks, not when the mask will arrive at your house.I will update abut production in the store news. Any information about shipping status, production delays or anything else customers need to know will be updated there: http://missmonster.myshopify.com/blogs/news
-This is for one (1) cast white urethane unpainted, unfinished mask.
-These are produced one at a time in my own studio. The eye holes will come opened, but the buyer will need to sand/remove the flash edges themselves. These can fit men and women comfortably and will be cast a bit thicker to give a solid “helmet” feel. A plastic nipper, a rasp , sandpaper or a dremel can be used to refine edges. Buyer should add foam to the inside of the mask to customize the fit. Some craft/paint/kit building knowledge is recommended. I cannot provide build help beyond the info included here.
-Please be sure to provide the correct address when placing your order, all orders will be shipped to the address im provided with. No exceptions, sorry!
-There are no refunds on pre-orders. Please do not buy a mask if this is an issue or if you are not comfortable with waiting.
If you want any more info on buying from my shop please go through the FAQ/policy page in my shop: http://missmonster.myshopify.com/pages/f-a-qk
The finished photos are just an example of what the mask can look like when completed. There are so many possibilities! I used a dremel to cut a line in one of the embellishments and installed LEDs to add a really cool look. I sculpted this to look like something a Japanese superhero might wear but it could be used for all sort of interesting characters.
This mask can be primed with any spray primer and painted with acrylics. Cut, sand, sculpt onto it, drill, and finish it to your liking! Seal with clear coat to prevent scuffs after painting. I recommend gluing elastic straps on the back sides to keep it on your face and gluing foam on the inside for comfort and proper fit.
This urethane is sensitive to heat. Please keep it out of direct sunlight as it can warp under it’s own weight when hot. It can be heat shaped by immersing it in very hot water and shaping gently while soft. You can also use a heat gun or heat in the oven at 175 degrees for a few minutes. Set the shape you want by immersing the warm mask in cold water.
This mask fits most faces but a perfect fit is not guaranteed.
Do not use this as safety equipment or a welding mask or anything else but costuming. Use common sense, please. I am not responsible for injuries sustained through improper use of this mask.
By purchasing this you acknowledge that you have read and agree with the shop’s policy page and acknowledge that you are prepared to wait.
X
