It's going to be very very hot in my area all this week which makes working in my outdoor casting workspace a little difficult. The heat makes the urethane kick faster than normal - it hardens almost immediately after mixing and cannot be poured into the mold in time to get a good cast. I will try a urethane with a longer work time but this also doesn't solve the issue of it being just too damn hot to physically tolerate for too long.
I will do my best to get around this by working outside once the sun goes down but ...well, i guess what im getting at is panther mask production will slow a bit for the next week. It's supposed to get a little cooler soon so hopefully casting can go back to normal speed and i can get all these masks poured, packed, kicked out and on their way!
Thank you for your patience!